Post-1995 Openers With CodeDodger®


Programming your Overhead Door Codedodger® wireless keypad

Resetting your keypad:

If, at any time, during programming, you should enter the wrong PIN or make a mistake, you should reset the keypad to its factory setting.

Open the keypad cover half way

Press and hold the number 8 and the PROG buttons while opening cover fully.

The indicator light will blink once and go out.

Close the cover. You are now ready to re-program your keypad.


Basic Programming:

Open cover fully - Indicator will blink once on go out

Press 3-5-7

Press PROG - Indicator will blink once per second

Enter PIN 1 (up to 8 digits)

Press PROG - Indicator will blink twice per second

Close cover. Your keypad is now ready to be programmed to the garage door opener.

Locate the Learn code button on your Codedodger garage door opener.

Depending on model, the learn code button will be located under the light cover or on the rear panel.


Basic Opener Programming:

Press the learn code button - Learn code LED will flash

Open cover on keypad fully

Enter PIN number

Press the SEND button 4 times, or until the door begins to operate.

You will now be able to use your wireless keypad normally.


Controlling a single door with your keypad:

Open keypad fully

Press PIN number

Press SEND once

Door should operate normally

NOTE: As a “panic” feature this keypad will operate door for up to 30 seconds from any button.


Programming multiple doors with your keypad:

Program your keypad according to the steps outlined in the Basic programming section listed above.

Open cover fully

Enter PIN number

Press PROG - Indicator will blink once per second

Press PROG - Indicator will blink twice per second

Press PROG - Indicator will blink three times per second

Enter the total number of doors (2 or 3)

Press PROG

Close cover

Your keypad is now ready to be program to the garage door openers.

Locate the learn code button on your garage door openers

Press the learn code button once - Learn code indicator will flash

Open cover on keypad fully

Enter PIN

Press SEND

Enter door number 1-2-or-3

Press send button 4 times, or until door operates

Repeat these steps for door 2 and 3

Controlling multiple doors:

Open cover fully

Enter PIN number

Press SEND

Enter door number (1-2-or 3)

Chosen door should operate

Adding PIN 2:

Open cover fully

Enter 1-5-9

Press PROG - Indicator will blink once per second

Enter PIN 2 (up to 8 digits)

Press PROG Indicator will go out

Close cover

Your keypad is now ready to be programmed to the garage door opener.

See steps in Basic programming.


Adding temporary PIN:

Open cover fully

Enter PIN 1

Press PROG - Indicator will blink once per second

Press PROG - Indicator will blink twice per second

Enter temporary PIN

Press PROG - Indicator will blink three times per second

Close cover

Your keypad is now ready to be programmed to the garage door opener.

See steps in Basic programming.


Canceling the temporary PIN:

The temporary PIN will remain active until PIN 1 is entered.


Changing a PIN:

Open cover fully

Enter PIN to be changed

Press PROG Indicator will blink once per second

Enter new PIN

Press PROG

Indicator will blink twice if PIN 1 has changed or go out if PIN 2 was changed

Close cover. Your keypad is now ready to be programmed to the garage door opener.

Locate the Learn code button on your Codedodger garage door opener.

Depending on model, the learn code button will be located under the light cover or on the rear panel.


Should you need additional information please contact our customer service department at 1-800-275-6187