5 Steps To Program Your HomeLink® System

Follow our 5 steps to program your Homelink system for your garage door in New England. Overhead Door of Southeastern Massachusetts is your source for all of your HomeLink inquiries. We have been in business for over 45 years providing the best service in the garage door industry and we pride ourselves in providing top quality work you can count on. We not only preach about it, but we in fact guarantee it. Our 100% satisfied or your money back guarantee makes sure if it. Rest assured that when you choose Overhead door, that you made the right choice.

 

Some vehicles may require the ignition be turned on or the vehicle actually running to program the Homelink® transceiver. To program a rolling code compatible Homelink® system, please follow these steps.

  1. Press and hold the two outside buttons on the Homelink® system until the LED starts to blink, release buttons.

  2. Press and hold the desired Homelink® button and the transmit button on your rolling code transmitter at the same time until the Homelink® LED changes from a slow blink to a rapid blink. (Your Homelink® system is now programmed)

  3. Locate the learn code button on your garage door opener. (These are located under the light cover or on the rear panel depending on model)

  4. Press the learn code button on the garage door opener, a red LED will start to blink. (You will have 30 seconds to complete programming.

  5. While the LED on the garage door opener is blinking, return to the vehicle and press the pre-programmed Homelink® button 4 times. (Or until the garage door operates).

Homelink® is a registered trademark of Johnson Controls, Inc.